Eastwood MIG 175 Evaluation | Eastwood Weblog

0
10



Why You Have to have This MIG Welder

Currently we’re going to speak about the MIG 175 and just how versatile it is. If you are seeking for one particular machine to do it all this is the one particular. It is ideal for auto restoration due to the fact you can weld something from thin sheet metal up to five/16 plate. If you place some .023 wire in you can hang a quarter panel or repair your floor pan. If you place some .035 wire in you can function on your chassis or welding tabs on a rear axle.

You can do just about something with this machine plus it comes with a spool gun as regular for welding aluminum so you can do some curb rash repair on an aluminum wheel or weld a tab back on a transmission.

This machine has been the workhorse of our welder line and we’ve had the chance to refine this machine more than the final ten years and it is the very best attainable welder for the DIY enthusiast. a

Inside our MIG 175 you will come across our higher high quality virgin copper effectively transformer. You will also see that the lamination stack is welded and setup. This is going to assure that no voids hum or create more than years

This is the rectifier that you will come across inside the machine. It is got a good aluminum heat sink to dissipate heat and assure that it’ll final for years to come and you will also see our new and enhanced metal drive motor. This is created to give a good smooth constant wire feed which is going to translate into a good smooth, constant weld.

Outdoors the machine you will come across an sector regular Tweco-style torch. This torch requires widespread consumables that are normally offered at Eastwood but are also offered at welding provide shops across the nation.

The MIG 175 has infinitely variable wire speed and heat settings. This is considerably greater than the old tap-style transformer exactly where you may well have 4 or 5 heat settings. Our infinite settings function actually permits you to dial in your weld.

Now that we’ve talked about the MIG 175 let’s get it set up and prepared to weld. Insert the brass physique of the torch lead by means of the front of the machine and then tighten the torch tensioner. Then connect the metal plug for the torch trigger into the front of the machine. The ground lead connection gets run by means of the front of the machine then up the wire loom on the backside of the panel. This secures the ground wire inside the machine. You can attach the ground terminal by working with the black knob. You want to normally make confident to flip the switch inside the machine to the welding gun position.

Now let’s set up the wire spool. Initially take away the wing nut, The spacer, and the plastic adapter. You are going to set the plastic adapter aside due to the fact that is only applied with eight-inch spools. Then set up the wire spool in the shaft followed by the spacer and then the wing nut sets the tension on the wire. Tighten the wing nut till there’s just a tiny bit of resistance and feed the wire into the drive motor and more than the roller and then into the torch hole. You can then drop the rocker arm down and lift up the stress adjuster to lock that wire into location.

Lastly we have to have to run wire by means of the torch so we can commence welding. Take away each the nozzle and the get in touch with tip. This aids the wire run by means of the lead without having receiving stuck. Pull the torch trigger to feed the wire and after your wires by means of the torch replace your get in touch with tip and the nozzle. You are now prepared to weld.

Hopefully that rapid overview and overview of the Eastwood MIG 175 welder is valuable and provides you far more specifics about the business enterprise finish of the welder. If you want to see our complete line of welders you can view them Right here.